Zebra Technologies P640i Manual Do Utilizador

Laminating Station

980541-001 Rev. A

P640i Card Printer User Guide

17

2.

Grasp the cassette and pull it straight 
toward you, clear of the printer.

3.

Open the cassette, like a clam shell, by 
separating its two halves. Grasp the two 
halves firmly with the fingers, then pull. 
Do NOT use tools to pry it apart.

1.

Discard the spent core. Hold the open 
cassette with its cavities toward you, 
white idler wheel to the top.

2.

Place a roll of laminate in the cassette so that it feeds from the bottom of the roll, UP and 
OUT to the front. Pull out an inch or two of laminate.

Caution • If you feel resistance when 
removing the cassette, the laminate has likely 
run out, leaving one end attached to the core 
and the other end under the cutter. Keep 
tugging on cassette, which will come free with 
a short tail of laminate.

Caution • Remove the transfer guide to be 
sure there are no scraps of laminate 
remaining.

Caution • You need partial width laminate for 
the LOWER cassette if there is a mag stripe 
or signature stripe on the card

Caution • If the lower cassette is intended for 
partial width laminate, it will have an edge 
guide to keep the laminate on track. Make 
sure it is in the correct position for the partial 
width laminate you are using.