Zebra Technologies P640i Manual Do Utilizador
34
P640i Card Printer User Guide
980541-001 Rev. A
Password Protection
Not the same as ID/Code. Password Protection blocks access to
various low level printer adjustment screens (including this
one). Check Use Password, then enter a password of your
choice.
various low level printer adjustment screens (including this
one). Check Use Password, then enter a password of your
choice.
Start
> Printers (or Printers and Faxes) > Right click Zebra
P640i > Properties > Device Settings > Control > Advanced
Utilites >
Utilites >
Show Sensor data
Start
> Printers (or Printers and Faxes) > Right click Zebra
P640i > Properties > General
Printing Preferences brings up the preferences screen, see Tech
Note 8, Windows Printer Driver.
Note 8, Windows Printer Driver.
Print Test Page prints the standard Windows test page, cropped
as shown here.
Start
> Printers (or Printers and Faxes) > Right click Zebra
P640i > Properties > Color Management
Sensor Data
Ribbon Panel Detect:
The current reading of the color
ribbon sensor.
Panel Threshold:
The current value of the detection
threshold for the color ribbon. Above this value is termed
“black,” below this value is termed “not black.”
“black,” below this value is termed “not black.”
Laminate Sensors:
Reflective sensor that detect the
presence of laminate on the transfer rollers: below threshold =
laminate present, above threshold = laminate absent.
laminate present, above threshold = laminate absent.
Card presence Sensor:
The reflective sensor to the right
of the card hopper: High = no card, Low = card present
Printhead Voltage:
Should be about 24V.
AC Frequency:
50 or 60 Hz
Assumed AC Voltage:
110V assumed for 60 Hz. If
frequency and voltage are not correct, see Laminate Station
Adjust, TN6-5
Adjust, TN6-5
Printhead Temperatue:
Temperature ceiling 70°C (above
that temperature, printing is stopped until the head cools).
Controller Board Temperature:
Should be about 5°
above ambient.
Heater Temperature:
Temperatures at the top and bottom
laminate heater cores.
Logic States:
Summarizes all two-state interlocks and
photosensors - a very useful diagnostic tool.
Printer Properties
Table 1: General
Printer Properties
Table 1: Color
Management
Not currently supported