Orbit Manufacturing 2000 Manual Do Utilizador
Page 8 - 10
Maintenance
© GBC Films Group January 2001
Orbit™ 2000 Operation and Maintenance Manual
8.2.4 Paper release adjustment
W A R N I N G
CAUTION: Only a qualified service technician may perform this set-up.
W A R N I N G
WARNING: Press the stop button before performing the following set-up procedure!
Proper feeding is obtained by setting the lift and release of the paper for correct timing. For correct
feeding, the instant of paper release and the instant of suction must be adjusted precisely. The adjustment
is done by turning the slide valve ( p ).
is done by turning the slide valve ( p ).
q
The instant of release must be 1.5 to 2 mm before top dead center; suction is adjusted simultaneously.
At the moment of suction, the cups are in the rear position and start dropping. The correct position of the
slide valve ( q ) is factory adjusted, and is marked by a paint filled drilled hole.
slide valve ( q ) is factory adjusted, and is marked by a paint filled drilled hole.