Psion Teklogix PX750 Manual Do Utilizador

Scan Result
When this parameter is enabled, the type of bar code and the result of the scan appear on the 
screen. Note that this information is only displayed after a successful decode and is visible 
only while the scanner trigger is pressed. When the trigger is released, this information is 
cleared from the screen.

Scan Indicator
When this parameter is enabled, the laser warning logo appears on the display whenever the 
scanner is activated.

Scan Result Time (sec)
The value assigned to the “Scan Result Time (sec)” parameter determines how long the scan 
results of a successful scan are displayed on the screen. Time is measured in seconds, and a 
value of “0” (zero) disables the parameter. When you choose this option, a dialog box 
appears where you can enter a value.

Good Scan Beep And Bad Scan Beep
These parameters determine whether or not the NEO emits an audible scanner ‘beep’ when 
a good (successful) scan or a bad (unsuccessful) scan is performed. Set these parameters to 
either on to enable the beeper or off to disable it.

Soft Scan Timeout
This parameter is used by the SDK “Scan” function (soft-scan: starting a scan session via the 
SDK function, instead of a physical user trigger press). The value assigned to this parameter 
determines the soft-scan timeout from 1 to 10 sec. (default is 3 sec.). 

Scan Log File
If this parameter is enabled, the input barcode and the modified/translated output bar code 
are logged in the file \Flash Disk\ScanLog.txt. Keep in mind that if the “Scan Log File” is 
enabled, there is a slight performance effect when performing multiple scans since the log 
file is written to persistent storage.