Toshiba M30-35 Manual Do Utilizador

To remove the USB board/DC-IN jack/network jack, follow the steps below and refer to 
figure 4-34. 

1.  Remove the following screw securing the USB board. 

•  M2.5×4B  FLAT HEAD screw   

 

×1 

2. Disconnect the USB cable from the connector CN1 on the USB board. 

3.  Peel off the acetate tape and remove the network jack from the slot. 

4. Disconnect the DC-IN jack cable from the connector CN1 on the power board and 

remove the DC-IN jack. 

M2.5

×4B FLAT HEAD

USB board

DC-IN jack

Network jack

USB cable

Acetate tape