Toshiba M30-35 Manual Do Utilizador

To remove the sensor/switch board, make sure the computer is in boot mode and powered 
off, follow the steps below and refer to figure 4-42. 

1.  Remove the following screws securing the sensor/switch board. 

•  M2×4B  S-FLAT HEAD screw  

 

×1 

2. Remove the sensor/switch board. 

M2×4B S-FLAT HEAD

Sensor/Switch board

 

3.  Pull out the sensor/switch board cable. 

To install the sensor/switch board, make sure that the computer is in boot mode and powered 
off, follow the steps below and refer to figure 4-42. 

1. Place the sensor/switch board in the slot and secure it with the following screw. 

•  M2×4B  S-FLAT HEAD screw  

 

×1 

2.  Pass the sensor/switch board cable through the hole under the hinge cover. 

3. Arrange the sensor/switch board cable along with the guides.