Toshiba S4 Manual Do Utilizador

4.8 Slim select bay module

4 Replacement Procedures

TECRA S3 Maintenance Manual (960-532)

[CONFIDENTIAL]

4-19

4.8 Slim select bay module

Removing the Slim select bay module

To remove the slim select bay module, follow the steps below and refer to Figure 4-8 and 4-
9. The explanation and figure shown below are the optical drive removing/installing. As for
other module, the procedure is same.

CAUTION: Do not put fingers in the slim select bay module. It may cause injury.

1. Remove the following screw securing the latch and drive the removed screw into the

screw hole. (The slim select bay is unlocked.)

• M2.5×4B FLAT HEAD screw

×1

2. While sliding the latch toward the arrow direction in the Figure 4-8, pull out the slim

select bay module to disconnect it from the system board.

Figure 4-8 Removing the slim select bay module

CAUTION: When using the DVD super multi drive as the slim select bay module, the

removed drive must be kept in an ultra slim bay case.

M2.5

×4B FLAT HEAD

Slim select bay module

Latch