Viewsonic VPC100 Manual Do Utilizador

ViewSonic  VPC100

26

To set or change the user password:

Select 

Change User Password.

Type the password, then press [Enter]. The password can be an 

alphanumeric character of up to 6 characters in length.
Re-type the password to confirm, then press [Enter].

The Access level defined by the Supervisor determines the users’ setup utility 

access.

When a Supervisor or User password has been set, the 

Password Check option 

will be available in the Security Menu.  With this option, you can configure when the 

system will prompt you for the password:

Setup: You are required to enter the password every time you access the 

BIOS Setup Utility.
Always: You are required to enter the password on every system boot.

Select 

Change Supervisor Password.

When prompted to enter the new password, just press [Enter].
A message will appear to confirm password is uninstalled. Press [Enter].

Select 

Clear User Password.

A message will appear to confirm clearing of password, select 

Ok then press 

[Enter].

NOTE
Once you have set the Supervisor Password, you cannot start your computer 

without entering the password. Be sure not to forget the password. Write down your 

password and keep it safe and private from other people.

1.
2.

3.

1.
2.
3.

1.
2.