Toshiba L310 Manual Do Utilizador

User’s Manual

xiii

■

When used in the Auto Answer mode, the S0 register must be set with a 

value of 3 or 4. This ensures:

■

a person calling your modem will hear a short burst of ringing before 

the modem answers. This confirms that the call has been 

successfully switched through the network.

■

caller identification information (which occurs between the first and 

second ring cadences) is not destroyed.

■

The preferred method of dialling is to use DTMF tones (ATDT...) as this 

is faster and more reliable than pulse (decadic) dialling. If for some 

reason you must use decadic dialling, your communications program 

must be set up to record numbers using the following translation table 

as this modem does not implement the New Zealand “Reverse dialling” 

standard.
Number to be dialled: 0 1 2 3 4 5 6 7 8 9
Number to program into computer: 0 9 8 7 6 5 4 3 2 1
Note that where DTMF dialling is used, the numbers should be entered 

normally.

■

The transmit level from this device is set at a fixed level and because of 

this there may be circumstances where the performance is less than 

optimal. Before reporting such occurrences as faults, please check the 

line with a standard Telepermitted telephone, and only report a fault if 

the phone performance is impaired.

■

It is recommended that this equipment be disconnected from the 

Telecom line during electrical storms.

■

When relocating the equipment, always disconnect the Telecom line 

connection before the power connection, and reconnect the power first.

■

This equipment may not be compatible with Telecom Distinctive Alert 

cadences and services such as FaxAbility.
NOTE THAT FAULT CALLOUTS CAUSED BY ANY OF THE ABOVE 

As required by PTC 100, please ensure that this office is advised of any 

changes to the specifications of these products which might affect 

compliance with the relevant PTC Specifications.
The grant of this Telepermit is specific to the above products with the 

marketing description as stated on the Telepermit label artwork. The 

Telepermit may not be assigned to other parties or other products without 

Telecom approval.
A Telepermit artwork for each device is included from which you may 

prepare any number of Telepermit labels subject to the general instructions 

on format, size and color on the attached sheet.
The Telepermit label must be displayed on the product at all times as proof 

to purchasers and service personnel that the product is able to be 

legitimately connected to the Telecom network.
The Telepermit label may also be shown on the packaging of the product 

and in the sales literature, as required in PTC 100.