Toshiba 960-809 Manual Do Utilizador

When the power is turned on, the system performs the Initial Reliability Test (IRT) installed 
in the BIOS ROM. When the test detects an error, an error message is displayed on the screen. 

Make sure no floppy disk is in the FDD. Turn on the computer and check the message on the 
screen. When an OS starts from the 2.5” HDD, go to Procedure 3. Otherwise, start with Check 
1 below and perform the other checks as instructed. 

Check 1  If any of the following messages appear, go to Procedure 3. If the following 

messages do not appear, perform Check 2. 

HDC ERROR 

 

or 

HDD #X ERROR

     

(After 5 seconds this message will disappear.)

  

Check 2  If either of the following messages appears, go to Check 3. If the following 

messages do not appear, perform Check 4. 

Insert system disk in drive 
Press any key when ready ..... 

or 

Non-System disk or disk error 
Replace and press any key when ready

 

Check 3  Using the SYS command of the DOS, transfer the system to the 2.5” HDD. If the 

system is not transferred, go to Procedure 3. Refer to the DOS Manual for detailed 
operation. 

If the following message appears on the display, the system program has been 
transferred to the HDD. 

System Transferred 

If an error message appears on the display, perform Check 4. 

Check 4  2.5” HDD(s) and the connector(s) of system board may be defective (Refer to the 

steps described in Chapter 4, Replacement Procedures for disassembling.). Insert 
HDD(s) to the connector(s) firmly. If it is (or they are) firmly connected, go to 
Procedure 3.