Toshiba A1 Manual Do Utilizador

The following describes the procedure for installing the wireless LAN antenna, display cover, 
and display cable (See Figure 4-37 to 4-44). 

1.  Install the hinges to the display assembly and secure them with the following screws. 

•  M2.5x6   

PSP TIGHT screw 

x3 (Left: 2, Right:1) 

•  M2.5x5   

THIN BIND screw  x1 (Right) 

2.  Install the left and right speaker nets and bend the edges (at four points each) using a 

device such as a flatblade driver and secure them. 

3.  Install the display cover to the display assembly. 

4.  Open the display at 45-degree slant and secure the hinges to the display cover with 

the following screws. 

•  M2.5x2.8   

THIN BIND screw  x2 

5.  Secure the hinges to the display cover with the following screws. Stick two mask 

seals on each side of the display cover. 

•  M2.5x2.8   

THIN BIND screw  x4 (Display cover side) 

•  M2.5x6   

THIN BIND screw  x2 (FL inverter side) 

6.  (For wireless LAN models only) 

Fit the wireless LAN antennas to the grooves at the rear of the display cover with 
double-sided adhesive tapes. Set the wireless LAN antenna cables and stick four 
acetate tapes on the cables. 

7.  (For wireless LAN models only) 

Pass the wireless LAN antenna cables through the bottom of the display cover toward 
the back side of the display assembly. 

8.  Pass the LCD cable from the bottom of the display cover toward the back side of the 

display assembly. Then install the LCD cable holder and secure the holder with the 
following screw. 

•  M2.5x4   

PSP TIGHT screw 

x1 

9.  Turn the display assembly face down. Close the display and attach the hinge cover. 

Then open the display and secure two latches of the hinge cover. Turn the display 
assembly face down and secure the hinge cover with the following screw. 

•  M2.5x4   

PSP TIGHT screw 

x1