Toshiba A1 Manual Do Utilizador

Removing the board assembly, tape pad, sheets, light guide, bottom cover (B), and lamp 
assembly 

1.  Remove the board assembly (Board Ass’y) (1). Perform this work in a clean room 

and be careful not to scratch or get dirt on the polarized plate and B/L assembly. 

2.  Remove the tape pad (Tape Pad) fixing the sheets (2). 

3.  Remove the sheets and light guide (Sheets&LGP) (3). Be careful not to scratch or get 

dirt on the sheets. 

4.  Remove the screws and bottom cover (B) (4). The screw tightening torque is 

2.0kgf.cm maximum. 

5.  Remove the low voltage cable from the mold frame, then remove the lamp assembly 

from the mold frame (5). Be careful not to apply excessive force. Do not leave any 
dirt or double-sided tape glue on the mold frame.