Toshiba 960-498 Manual Do Utilizador

The following describes the procedure for removing the SJ board (See Figure 4-37). 

1.  Disconnect the microphone cable from the connector CN6000 on the SJ board. 

2.  Unlock the connector CN9560 on the SJ board and disconnect the SJ board flat 

cable from it. 

3.  Remove the following screw fixing the SJ board and remove the SJ board. 

•  M2×4Z BIND 

screw   x1 

4.  Remove the glass tape and pull out the SJ board flat cable from the slit of the 

middle frame. 

 

M2x4Z  BIND 

SJ board flat cable

Guide lines 

Insulator 

CN9560

Glass tape 

SJ board 

Slit 

CN6000 

Microphone cable