Acer Altos G710 Manual Do Utilizador
39
Installation precautions
Before you install any server component, we recommend that you read
the following sections. These sections contain important ESD
precautions along with preinstallation and post-installation
instructions.
the following sections. These sections contain important ESD
precautions along with preinstallation and post-installation
instructions.
ESD precautions
Electrostatic discharge (ESD) can damage your processor, disk drives,
expansion boards, motherboard, memory modules and other
components. Always observe the following precautions before you
install a server component:
expansion boards, motherboard, memory modules and other
components. Always observe the following precautions before you
install a server component:
1
Do not remove a component from its protective packaging until
you are ready to install it.
you are ready to install it.
2
Wear a wrist grounding strap and attach it to a metal part of the
server before handling components. If a wrist strap is not
available, maintain contact with the server throughout any
procedure requiring ESD protection.
server before handling components. If a wrist strap is not
available, maintain contact with the server throughout any
procedure requiring ESD protection.
Preinstallation instructions
Always observe the following before you install any component:
1
Turn off the system and all the peripherals connected to it.
2
Unplug all cables from the power outlets.
3
Place the system unit on a flat, stable surface.
4
Open the system according to the instructions on page 41.
5
Remove the air baffle.
6
Follow the ESD precautions described in this section when
handling a server component.
handling a server component.
7
Remove any expansion board(s) or peripheral(s) that block access
to the DIMM slots or other component connector.
to the DIMM slots or other component connector.
See the following sections for specific installation instructions on the
component you want to install.
component you want to install.