Emerson ATCA-7150 Manual Do Utilizador

ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)

RTM-ATCA-7150 must be installed before the ATCA-7150 to avoid product damage. For  
information on how to install the RTM-ATCA-7150, refer to 

The following procedure describes the installation of the blade. It assumes that your system is 
powered and if applicable the RTM is installed. If your system is unpowered, you can disregard 
the blue LED and thus skip the respective step. In this case it is a purely mechanical installation.

1. Wear the ESD-preventive wrist strap.

For details, see 

2. Take the ATCA-7150 out of the antistatic package.

3. Fully open the upper and lower ejector handles.

4. Slide the ATCA-7150 along the guide rails until the positioning pins of the ATCA-7150 are 

inserted in the positioning holes in the shelf, as shown in 

.

5. Make sure that the upper and lower ejector handles are attached to the beam properly. 

Close the upper and lower ejector handles until the inner sides of the ejector handles are 
attached to the face plate, as shown in 

. After closing the handles, the blue LED, 

OOS and HEALTHY LEDs blink. When payload is powered on, the blue LED is continously 
illuminated, and the OOS and HEALTHY LEDs are out.