Duracell MN 1400 Manual Do Utilizador

SECTION 7: HANDLING AND STORAGE 

 
Avoid mechanical or electrical abuse. DO NOT short circuit or install incorrectly. Batteries may explode, 
pyrolize or vent if disassembled, crushed, recharged or exposed to high temperatures. Install batteries in 
accordance with equipment instructions. Do not mix battery systems, such as alkaline and zinc carbon, in 
the same equipment. Replace all batteries in equipment at the same time. Do not carry batteries loose in a 
pocket or bag. Do not remove battery tester or battery label.  
 
Storage:  Store batteries in a dry place at normal room temperature. Do not refrigerate – this will not 
make them last longer. 
 

 
The following occupational exposure limits are provided for informational purposes. No exposure to the 
battery components should occur during normal consumer use. 
 

Manganese Dioxide 

5 mg/m3 Ceiling OSHA PEL 
0.2 mg/m3 TWA ACGIH TLV 

Zinc 

None established for zinc metal 

Potassium Hydroxide 

2 mg/m3 Ceiling ACGIH TLV 

Graphite (natural-non-fibrous)  

15 mppcf TWA OSHA PEL 
2 mg/m3 TWA (respirable dust) ACGIH TLV 

Graphite (synthetic non-fibrous) 

5 mg/m3 TWA (respirable dust), 15 mg/m3 TWA 
(total dust) OSHA PEL 
2 mg/m3 TWA (respirable dust) ACGIH TLV 

 
Ventilation: No special ventilation is needed for normal use. 
 
Respiratory Protection: None required for normal use. 
 
Skin Protection: None required for normal use.  Use neoprene, rubber or latex gloves when handling 
leaking batteries. 
 
Eye Protection:  None required for normal use.  Wear safety goggles when handling leaking batteries. 
 

SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES 

 
Appearance and Odor: Copper top battery.  
Specific Gravity: Not applicable  

Boiling Point: Not applicable 

Water Solubility: Insoluble 

Melting Point: Not applicable 

Vapor Pressure: Not applicable 

Flash Point: Not applicable 

Vapor Density: Not applicable 

Autoignition Point: Not applicable 

 

SECTION 10: STABILITY AND REACTIVITY 

 
Stability:  This product is stable. 
 
Incompatibility/Conditions to Avoid:  Contents are incompatible with strong oxidizing agents. Do not 
heat, crush, disassemble, short circuit or recharge.