Banner DX81 Folheto
Delivers and manages dc voltage from one 3.6V dc lithium primary battery
SureCross™ DX81
FlexPower™ Supply Module
WARNING…
Not to be used for personnel protection
Never use these products for personnel protection. Doing so could lead to serious injury or death.
These products do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety
applications. A failure or malfunction can cause either an energized or de-energized product output condition. Consult your
current Banner Safety Products catalog for safety products that meet OSHA, ANSI, and IEC standards for personnel protection.
applications. A failure or malfunction can cause either an energized or de-energized product output condition. Consult your
current Banner Safety Products catalog for safety products that meet OSHA, ANSI, and IEC standards for personnel protection.
Printed in USA
11/07
P/N 131596 rev. C
Model
Power
Batteries
Cable
DX81
3.6V dc Battery
One 3.6V Lithium “D” Cell
5-pin Euro Pigtail QD
Models
Features
Wireless solution for powering a FlexPower™ Node and sensor device
Unique power management system to run the FlexPower Node and a device through
Unique power management system to run the FlexPower Node and a device through
switched power outputs for up to five years, depending upon the power requirements of
the device
Replaceable 3.6V dc Lithium “D” cell battery
IP67 sealed enclosure
Replaceable 3.6V dc Lithium “D” cell battery
IP67 sealed enclosure
FlexPower systems allow for a true wireless solution as the Node can be powered
by battery power (3.6 to 5.5V dc). Battery life is application specific. Contact Banner
Engineering’s application engineers for a battery life calculation for your specific
application.
For additional information and a complete list of replacement parts, please refer to Banner
For additional information and a complete list of replacement parts, please refer to Banner
Engineering’s website,
•
•
•
•
•
•
Battery Replacement
Battery Replacement
To replace the lithium “D” cell battery in the DX81 FlexPower™ battery kit,
Remove the four screws mounting the battery pack face plate to the body.
Remove the face plate.
Remove the discharged battery and replace with a new battery. Verify the battery’s
Remove the face plate.
Remove the discharged battery and replace with a new battery. Verify the battery’s
positive and negative terminals align to the positive and negative terminals of the battery
holder mounted within the case. Caution: Risk of explosion of battery is replaced with an
incorrect type.
After replacing the battery, allow up to 60 seconds for the device to power up.
After replacing the battery, allow up to 60 seconds for the device to power up.
When removing the battery, press the battery towards the negative terminal to compress
the spring. Pry up on the battery’s positive end to remove from the battery holder. Properly
dispose of your used battery according to local regulations by taking it to a hazardous waste
collection site, an e-waste disposal center, or any other facility qualified to accept lithium
batteries.
As with all batteries, these are a fire, explosion, and severe burn hazard. Do not burn or
As with all batteries, these are a fire, explosion, and severe burn hazard. Do not burn or
expose them to high temperatures. Do not recharge, crush, disassemble, or expose the
contents to water.
1.
2.
3.
2.
3.
4.