Optoma Technology X600 Manual Do Utilizador

14

Warning Indicator

▀

■

 When the Lamp LED indicator lights red, the projector will 

automatically shut itself down. Please contact your local 

reseller or service center. See 

.

▀

■

 When the Temp LED is on a steady (not flashing) red, the 

projector will automatically shut itself down. Under normal 

conditions, the projector can be switched on again after it 

has cooled down. If the problem persists, you should contact 

your local dealer or our service center. See 

.

Powering Off the Projector

1.  Press the 

"

"

 button on the remote control or 

"

"

 button on 

the panel

 of the projector 

to turn off the projector. First push of 

button will display the following message on the screen.

Press the button again to confirm the shut down. If the button is not 

pressed, the message will disappear in 5 seconds.

2.  The Power LED flashes green (1 sec on, 1sec off) and the fans will 

speed up during shut down cooling cycle. The projector reaches 

stand-by mode as soon as the Power LED flashes green (2 sec on, 

2 sec off).
If you wish to turn the projector back on, you must wait until the 

projector has completed the cooling cycle and has entered standby 

mode. Once in standby mode, simply press "

" button on the 

rear of the projector or "

" on the remote control to restart the 

projector.

3.  Disconnect the power cord from the electrical outlet and the 

projector only when the projector is in stand-by mode.

Contact the nearest 
service center if the 
projector displays 
these symptoms. See 
page 84 for more 
information.