NEC NC2500S Manual Do Utilizador
7
1. What’s in the Box? and the Names of the Projector Parts
1-3-2. Rear of the projector
1
4
5
3
2
1. Air inlet
Air is taken in here to provide cooling of the projector. Do not cover the air inlet.
2. Level adjusters (in four positions on bottom)
In the ordinary installation, you can adjust the projector inclination at 4 positions.
3. Tilt feet (in two positions on bottom)
These adjust the tilting angle of the projector. Please contact your dealer/distributor to setup and adjust this projector.
4. Lamp door
This opens to allow the lamp to be replaced. Please contact your dealer/distributor to install and to replace the lamp bulb
and lamp house.
5. Rear status indicator
These indicate the status of the projector. When the projector is operating normally, these light/blink in green or orange.
When an error occurs, they light/blink in red. When an error occurs, check the contents of the display on the LCD screen.
(See page 39)
NOTE
• Do not cover the air inlet and outlet during operation. Inadequate air intake may lead to a rise in inside
temperature, thus causing a free or serious projector failure.
Caution:
Only service personnel should open the lamp door.