3M 800r3 Manual Do Utilizador
7
1.
Power Requirements:
Electrical – 115 VAC, 60 Hz, 3.8 A (440 watts)
Pneumatic – 6.5 bar gauge pressure [95 PSIG]
Pneumatic – 6.5 bar gauge pressure [95 PSIG]
110 litre/min @ 21
°
C, 1.01 bar
[3.75 SCFM] at 15 boxes per
minute
minute
The machine is equipped with two 1/6 HP
gearmotors and comes with a 2.4 meter [8 ft]
long standard neoprene covered power cord
and a grounded plug. Contact your 3M
Representative for power requirements not
listed above.
gearmotors and comes with a 2.4 meter [8 ft]
long standard neoprene covered power cord
and a grounded plug. Contact your 3M
Representative for power requirements not
listed above.
2.
Operating Rate:
Up to 15 boxes per minute. Actual production
rate is dependent on box size, box size mix, and
operator dexterity.
rate is dependent on box size, box size mix, and
operator dexterity.
Box drive belt speed is 24 m/m [78 FPM]
3.
Operating Conditions:
Use in dry, relatively clean environments at 4
°
to
50
°
C [40
°
to 120
°
F] with clean, dry, boxes.
Note – Machine should not be washed down or
subjected to conditions causing moisture
condensation on components.
subjected to conditions causing moisture
condensation on components.
4.
Tape:
Scotch
TM
brand pressure-sensitive film box
sealing tapes.
5.
Tape Width:
48 mm [2.0 in] minimum to
72 mm [3.0 in] maximum
72 mm [3.0 in] maximum
6.
Tape Roll Diameter:
Up to 405 mm [16.0 in] maximum on a
76.2 mm [3.0 in] diameter core.
(Accommodates all system roll lengths of
Scotch
76.2 mm [3.0 in] diameter core.
(Accommodates all system roll lengths of
Scotch
TM
brand film tapes.)
7.
Tape Application Leg Length – Standard:
70 mm
±
6 mm [2.75 in
±
.25 in]
Tape Application Leg Length – Optional:
(See "Special Set-Up Procedure", page 24)
(See "Special Set-Up Procedure", page 24)
50 mm
±
6 mm [2.00 in
±
.25 in]
8.
Box Board:
Style – regular slotted containers – RSC
125 to 275 P.S.I. bursting test, single wall or
double wall B or C flute.
125 to 275 P.S.I. bursting test, single wall or
double wall B or C flute.
(Specifications continued on next page)
Specifications