3M 800rf Manual Do Utilizador

23 

800rf-NA

2012 March

(continued)

See Manual 2 for Complete Instructions:

1.  Place the Upper Taping Head in a convenient 

working position

.2. Use Figure 7-22 and tape threading label. 

Position the tape supply roll so the adhesive 
side of tape is facing the front of the taping head 
as it is pulled from the supply roll. 

3.  Attach the threading needle to the end of the 

roll. Guide the threading needle around the wrap 
roller (Position 1) then back around the one-
way tension roller (Position 2). 

4.  Continue pulling the threading needle down and 

guide it between the two (2) rollers on the apply 
arm (Position 3).

5.  Pull the threading needle down until the tape 

travels between the apply plate and the ears of 
the apply arm (Position 4) until it extends past 
the applying roller.  When properly threaded the 
adhesive side of the tape should be facing the 
knurled rollers at position 2 and also position 3. 

6.  Cut away any excess tape and repeat steps for
  

Lower Taping Head.

  Do not cut against the apply roller -  

                      roller damage could occur.