Cabletron Systems CSX1000 Manual Do Utilizador
Workgroup Remote Access Switch 189
C
ONFIGURING
N
ETWORK
L
OGIN
I
NFORMATION
Network Login General Configuration
Concerning item (9), Authentication Timeout, note the following recommendation: If using the
Security Dynamics Ace Server, modify the timeout value to be greater than the change
frequency value of the SecurID cards. Refer to the Security Dynamics documentation for more
information on this change frequency value. In addition, if you are using a VRA Manager for
call control management, this timeout value must represent the amount of time for the
authenticating agent to respond to the login attempt, and for VRA Manger to respond as well.
These times should be based on network configuration.
Security Dynamics Ace Server, modify the timeout value to be greater than the change
frequency value of the SecurID cards. Refer to the Security Dynamics documentation for more
information on this change frequency value. In addition, if you are using a VRA Manager for
call control management, this timeout value must represent the amount of time for the
authenticating agent to respond to the login attempt, and for VRA Manger to respond as well.
These times should be based on network configuration.
U
SING
M
ANAGE
M
ODE
netlogin
Displays the current network login configuration data. After entering the
netlogin
command, you will be prompted for the type of login configuration information you want. The
prompt will resemble the CFGEDIT screen in which this information was originally
configured. You may display: user level security general configuration, login banners, login
configuration specific to RADIUS, and login configuration specific to TACACS.
prompt will resemble the CFGEDIT screen in which this information was originally
configured. You may display: user level security general configuration, login banners, login
configuration specific to RADIUS, and login configuration specific to TACACS.
netlogin change
Allows you to change the current network login configuration data. After entering the
netlogin change
command, you will be prompted for the type of login configuration
information you want to change. The prompt will resemble the CFGEDIT screen in which this
information was originally configured. You may change: user level security general
configuration, login banners, login configuration specific to RADIUS, and login configuration
specific to TACACS.
information was originally configured. You may change: user level security general
configuration, login banners, login configuration specific to RADIUS, and login configuration
specific to TACACS.
N
ETWORK
L
OGIN
G
ENERAL
C
ONFIGURATION
B
ACKGROUND
I
NFORMATION
Allows you to change the network login prompts. These include the prompts for:
•
•
login ID
•
dynamic password
•
user password
•
old password, new password
•
passcode
You may also specify the number of login attempts, password change attempts and the amount of
time in seconds before an authentication timeout.
time in seconds before an authentication timeout.
When using DHCP to provide temporary IP addresses to remote clients, it is important to enable
BOOTP before Authentication if user authentication is used.
BOOTP before Authentication if user authentication is used.