IBM 12.1(22)EA6 Manual Do Utilizador
12-25
Cisco Systems Intelligent Gigabit Ethernet Switch Modules for the IBM BladeCenter, Software Configuration Guide
24R9746
Chapter 12 Configuring VLANs
Configuring VMPS
Configuring VMPS
The switch cannot be a VMPS server but can act as a client to the VMPS and communicate with it
through the VLAN Query Protocol (VQP). VMPS dynamically assigns dynamic access port VLAN
membership.
through the VLAN Query Protocol (VQP). VMPS dynamically assigns dynamic access port VLAN
membership.
This section includes this information about configuring VMPS:
•
•
•
•
•
•
•
Step 4
exit
Return to global configuration mode.
Step 5
Repeat Steps 2 through 4 on Switch A interface Gigabit Ethernet
port 0/18.
port 0/18.
Step 6
end
Return to privileged EXEC mode.
Step 7
show running-config
Verify your entries.
In the display, make sure that interfaces Gigabit Ethernet ports 0/17 and
0/18 are configured as trunk ports.
0/18 are configured as trunk ports.
Step 8
show vlan
When the trunk links come up, Switch A receives the VTP information
from the other switches. Verify that Switch A has learned the VLAN
configuration.
from the other switches. Verify that Switch A has learned the VLAN
configuration.
Step 9
configure terminal
Enter global configuration mode.
Step 10
interface gigabitethernet0/17
Enter interface configuration mode, and define Gigabit Ethernet
port 0/17 as the interface to set the STP cost.
port 0/17 as the interface to set the STP cost.
Step 11
spanning-tree vlan 2-4 cost 30
Set the spanning-tree path cost to 30 for VLANs 2 through 4.
Step 12
end
Return to global configuration mode.
Step 13
Repeat Steps 9 through 11 on Switch A interface Gigabit Ethernet
ports 0/18, and set the spanning-tree path cost to 30 for VLANs 8, 9, and
10.
ports 0/18, and set the spanning-tree path cost to 30 for VLANs 8, 9, and
10.
Step 14
exit
Return to privileged EXEC mode.
Step 15
show running-config
Verify your entries.
In the display, verify that the path costs are set correctly for interfaces
Gigabit Ethernet ports 0/17 and 0/18.
Gigabit Ethernet ports 0/17 and 0/18.
Step 16
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Command
Purpose