Juniper Networks EX8208 Manual Do Utilizador
The configured parameters are displayed. Enter
yes
to commit the configuration.
The configuration is committed as the active configuration for the switch. You can now
log in with the CLI or the J-Web interface to continue configuring the switch. If you use
the J-Web interface to continue configuring the switch, the Web session is redirected to
the new management IP address. If the connection cannot be made, the J-Web interface
displays instructions for starting a J-Web session.
log in with the CLI or the J-Web interface to continue configuring the switch. If you use
the J-Web interface to continue configuring the switch, the Web session is redirected to
the new management IP address. If the connection cannot be made, the J-Web interface
displays instructions for starting a J-Web session.
Related Topics
•
•
Installing and Connecting an EX2200 Switch
•
Installing and Connecting an EX3200 or EX4200 Switch
•
Installing and Connecting an EX4500 Switch
•
•
Installing and Connecting an EX8216 Switch
Connecting and Configuring an EX Series Switch (J-Web Procedure)
There are two ways to connect and configure an EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the J-Web procedure.
the console using the CLI and the other is using the J-Web interface. This topic describes
the J-Web procedure.
NOTE: Before you begin the configuration, enable a DHCP client on the management
PC you will connect to the switch so that the switch can obtain an IP address
dynamically.
PC you will connect to the switch so that the switch can obtain an IP address
dynamically.
NOTE: Read the following steps before you begin the configuration. You must complete
the initial configuration using EZSetup within 10 minutes. The switch exits EZSetup
after 10 minutes and reverts to the factory default configuration, and the PC loses
connectivity to the switch.
the initial configuration using EZSetup within 10 minutes. The switch exits EZSetup
after 10 minutes and reverts to the factory default configuration, and the PC loses
connectivity to the switch.
•
EX2200 switch—The LEDs on the network ports on the front panel blink when the
switch is in the initial setup mode.
switch is in the initial setup mode.
•
EX3200, EX4200, EX4500, or EX8200 switch—The LCD displays a count-down timer
when the switch is in initial setup mode.
when the switch is in initial setup mode.
Copyright © 2010, Juniper Networks, Inc.
192
Complete Hardware Guide for EX8208 Ethernet Switches