Juniper Networks EX8208 Manual Do Utilizador
•
Optical Interface Support in EX2200 Switches
•
Optical Interface Support in EX3200 and EX4200 Switches
•
Optical Interface Support in EX4500 Switches
•
Removing the Power Cord Tray from a Rack or Cabinet for an EX8200 Switch
You can remove the power cord tray from a rack or cabinet. (The remainder of this topic
uses “rack” to mean “rack or cabinet.”)
uses “rack” to mean “rack or cabinet.”)
In two-post rack installations, we recommend that you do not remove the power cord
tray unless you are also removing the switch and that you remove the switch before you
remove the power cord tray.
tray unless you are also removing the switch and that you remove the switch before you
remove the power cord tray.
NOTE: The EX8216 switch can be installed only in a four-post rack. Installation in a
two-post rack is not supported.
two-post rack is not supported.
If you remove the power cord tray before removing the EX8208 switch from a two-post
rack, there is no support for the underside of the switch. This creates a problem if and
when you need to remove the switch, because the chassis has no support once you
remove the screws that hold the front-mounting brackets to the rack. In a four-post rack
this is not an issue because the switch rests on the adjustable mounting brackets.
rack, there is no support for the underside of the switch. This creates a problem if and
when you need to remove the switch, because the chassis has no support once you
remove the screws that hold the front-mounting brackets to the rack. In a four-post rack
this is not an issue because the switch rests on the adjustable mounting brackets.
Before you begin to remove the power cord tray:
•
Ensure no power cables are resting on or threaded through the power cord tray.
•
Remove the switch if the switch and power cord tray are installed on a two-post rack.
See “Removing an EX8208 Switch from a Rack or Cabinet” on page 201.
See “Removing an EX8208 Switch from a Rack or Cabinet” on page 201.
Ensure that you have the following parts and tools available to remove the power cord
tray:
tray:
•
A Phillips (+) screwdriver, number 1, 2, or 3, depending on the size of your rack mounting
screws
screws
To remove the power cord tray:
1.
Use the appropriate Phillips (+) screwdriver to remove the four mounting screws
that hold the power cord tray in the rack.
that hold the power cord tray in the rack.
2.
Remove the power cord tray and store it in the original switch accessory box for later
use.
use.
Related Topics
•
Copyright © 2010, Juniper Networks, Inc.
224
Complete Hardware Guide for EX8208 Ethernet Switches