Juniper Networks EX4200 Manual Do Utilizador

■

The switch you are mounting has an uplink module with transceivers installed
in it—the transceivers in the uplink module ports protrude from the front of the
switch.

To mount the switch in a recessed position on four posts, follow the instructions in
“Mounting an EX3200 or EX4200 Switch on Four Posts in a Rack or Cabinet” on
page 121. To mount the switch in a recessed position on two posts, follow the
instructions in “Mounting an EX3200 or EX4200 Switch on Two Posts in a Rack or
Cabinet” on page 118.

Related Topics

■

■

Mounting an EX3200 or EX4200 Switch on a Wall

You can mount an EX3200 or EX4200 switch on a wall by using the separately
orderable wall-mount kit.

Before mounting an EX3200 or EX4200 switch on a wall:

■

Verify that the site meets the requirements described in “Site Preparation
Checklist for EX3200 and EX4200 Switches” on page 81.

■

Read “General Safety Guidelines and Warnings for EX Series Switches” on
page 207, with particular attention to “Chassis Lifting Guidelines for EX3200 and
EX4200 Switches” on page 220.

■

Remove the switch from the shipping carton (see “Unpacking an EX3200 or
EX4200 Switch” on page 114).

Ensure that you have the following parts and tools available to mount the switch on
a wall:

■

Phillips (+) screwdriver, number 2

■

2 wall-mount brackets (provided with the wall-mount kit)

■

12 wall-mount bracket screws (provided with the wall-mount kit)

■

4 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not included)

■

Dust covers for ports (for EX4200-24F switches only; optional)

■

Hollow wall anchors capable of supporting the combined weight of two fully
loaded switches, up to 44 lb (20 kg) (not included)—if you are mounting the
switch in sheetrock (wall board with a gypsum plaster core) or in wall board not
backed by wall studs

Mounting an EX3200 or EX4200 Switch on a Wall

■

125

Chapter 9: Installing the Switch