Juniper Networks EX4200 Manual Do Utilizador
■
■
Installing a Fan Tray in an EX3200 or EX4200 Switch
EX3200 and EX4200 switches have a single field-replaceable unit (FRU) fan tray on
the rear panel. The fan tray is a hot-removable and hot-insertable FRU: You can
remove and replace it without powering off the switch or disrupting switch functions.
the rear panel. The fan tray is a hot-removable and hot-insertable FRU: You can
remove and replace it without powering off the switch or disrupting switch functions.
Before you begin installing a fan tray in an EX3200 or EX4200 switch, ensure that
you have taken the necessary precautions to prevent ESD damage (see “Prevention
of Electrostatic Discharge Damage on EX Series Switches” on page 236).
you have taken the necessary precautions to prevent ESD damage (see “Prevention
of Electrostatic Discharge Damage on EX Series Switches” on page 236).
Ensure that you have the following parts and tools available to install a fan tray in
an EX3200 or EX4200 switch chassis:
an EX3200 or EX4200 switch chassis:
■
Electrostatic discharge (ESD) grounding strap
■
Phillips (+) screwdriver, number 2
To install a fan tray in an EX3200 or EX4200 switch chassis (see Figure 47 on page 132
and Figure 48 on page 133):
and Figure 48 on page 133):
1.
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to the ESD point on the chassis.
connect the strap to the ESD point on the chassis.
CAUTION: If you are installing a fan tray in an EX3200 switch, ensure the fan faces
upwards. If you are installing a fan tray in an EX4200 switch, ensure the fans face
downwards.
upwards. If you are installing a fan tray in an EX4200 switch, ensure the fans face
downwards.
2.
Remove the fan tray from its bag. Using both hands, align the tray with the fan
tray guides on the fan tray slot on the rear panel of the chassis and slide it in
until it is fully seated.
tray guides on the fan tray slot on the rear panel of the chassis and slide it in
until it is fully seated.
3.
Tighten the screw or screws on the fan tray by using the Phillips (+) screwdriver,
number 2.
number 2.
Figure 47: Installing a Fan Tray in an EX3200 Switch
132
■
Installing a Fan Tray in an EX3200 or EX4200 Switch
Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches