Cisco Systems 3560 Manual Do Utilizador
12-12
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 12 Configuring Auto Smartports Macros
Configuring Static Smartports Macros
Static Smartports Configuration Guidelines
•
When a macro is applied globally to a switch or to a switch interface, all existing configuration on
the interface is retained. This is helpful when applying an incremental configuration.
the interface is retained. This is helpful when applying an incremental configuration.
•
If a command fails because of a syntax or a configuration error, the macro continues to apply the
remaining commands. You can use the macro global trace macro-name global configuration
command or the macro trace macro-name interface configuration command to apply and debug a
macro to find any syntax or configuration errors.
remaining commands. You can use the macro global trace macro-name global configuration
command or the macro trace macro-name interface configuration command to apply and debug a
macro to find any syntax or configuration errors.
•
Some CLI commands are specific to certain interface types. If you apply a macro to an interface that
does not accept the configuration, the macro fails the syntax or the configuration check, and the
switch returns an error message.
does not accept the configuration, the macro fails the syntax or the configuration check, and the
switch returns an error message.
•
Applying a macro to an interface range is the same as applying a macro to a single interface. When
you use an interface range, the macro is applied sequentially to each interface within the range. If a
macro command fails on one interface, it is still applied to the remaining interfaces.
you use an interface range, the macro is applied sequentially to each interface within the range. If a
macro command fails on one interface, it is still applied to the remaining interfaces.
•
When you apply a macro to a switch or a switch interface, the macro name is automatically added
to the switch or interface. You can display the applied commands and macro names by using the
show running-config user EXEC command.
to the switch or interface. You can display the applied commands and macro names by using the
show running-config user EXEC command.
Applying Static Smartports Macros
Beginning in privileged EXEC mode, follow these steps to apply a static Smartports macro:
Table 12-4
Default Static Smartports Macros
Macro Name
1
1.
Cisco-default Smartports macros vary, depending on the software version running on your switch.
Description
cisco-global
Use this global configuration macro to enable rapid PVST+, loop guard, and dynamic port error recovery
for link state failures.
for link state failures.
cisco-desktop
Use this interface configuration macro for increased network security and reliability when connecting a
desktop device, such as a PC, to a switch port.
desktop device, such as a PC, to a switch port.
cisco-phone
Use this interface configuration macro when connecting a desktop device such as a PC with a Cisco IP
Phone to a switch port. This macro is an extension of the cisco-desktop macro and provides the same
security and resiliency features, but with the addition of dedicated voice VLANs to ensure proper
treatment of delay-sensitive voice traffic.
Phone to a switch port. This macro is an extension of the cisco-desktop macro and provides the same
security and resiliency features, but with the addition of dedicated voice VLANs to ensure proper
treatment of delay-sensitive voice traffic.
cisco-switch
Use this interface configuration macro when connecting an access switch and a distribution switch or
between access switches connected by using small form-factor pluggable (SFP) modules.
between access switches connected by using small form-factor pluggable (SFP) modules.
cisco-router
Use this interface configuration macro when connecting the switch and a WAN router.
cisco-wireless
Use this interface configuration macro when connecting the switch and a wireless access point.
Command
Purpose
Step 1
show parser macro
Display the Cisco-default static Smartports macros embedded in the
switch software.
switch software.
Step 2
show parser macro name macro-name
Display the specific macro that you want to apply.
Step 3
configure terminal
Enter global configuration mode.