Cisco Systems 3560 Manual Do Utilizador

You should only configure and enable the Layer 3 interface. Do not assign an IP address or DHCP-based 
autoconfiguration with a saved configuration.

Beginning in privileged EXEC mode, follow these steps to manually assign IP information to multiple 
switched virtual interfaces (SVIs):

If the switch is running the IP services image, you can also manually assign IP information to a port if 
you first put the port into Layer 3 mode by using the no switchport interface configuration command.

To remove the switch IP address, use the no ip address interface configuration command. If you are 
removing the address through a Telnet session, your connection to the switch will be lost. To remove the 
default gateway address, use the no ip default-gateway global configuration command.

For information on setting the switch system name, protecting access to privileged EXEC commands, 
and setting time and calendar services, see 

Enter global configuration mode.

interface vlan vlan-id

Enter interface configuration mode, and enter the VLAN to which the IP 
information is assigned. The VLAN range is 1 to 4094. 

ip address ip-address subnet-mask

Enter the IP address and subnet mask.

Return to global configuration mode.

ip default-gateway ip-address

Enter the IP address of the next-hop router interface that is directly 
connected to the switch where a default gateway is being configured. The 
default gateway receives IP packets with unresolved destination IP 
addresses from the switch.

Once the default gateway is configured, the switch has connectivity to the 
remote networks with which a host needs to communicate.

When your switch is configured to route with IP, it does not need 
to have a default gateway set.

Return to privileged EXEC mode.

show interfaces vlan vlan-id 

Verify the configured IP address.

Verify the configured default gateway. 

(Optional) Save your entries in the configuration file.