Renesas M30850T2-EPB Manual Do Utilizador
M30850T2-EPB User’s Manual
3. Usage (How to Use the Emulator Debugger)
REJ10J1005-0200 Rev.2.00 April 1, 2007
3. Specifying a trace range
Specifying a trace range
4. Setting the trace write condition
You can specify a trace range for the trace event.
- Break
- Break
256K cycles of instruction execution before the user
program stopped is recorded.
program stopped is recorded.
- Before
256K cycles of instruction execution before a trace point
condition was met is recorded.
condition was met is recorded.
- About
128K cycles of instruction execution before and after a
trace point condition was met is recorded.
trace point condition was met is recorded.
- After
256K cycles of instruction execution after a trace point
condition was met is recorded.
condition was met is recorded.
- Full
256K cycles of instruction execution after a trace began is
recorded.
recorded.
Setting the trace write condition
You can specify a condition for the cycles to be written into
the trace memory.
- Total
All cycles are written into memory.
- Pick
up
Only the cycles in which the specified condition was met
are written into memory.
- Exclude
Only the cycles in which the specified condition was not
met are written into memory.
When you have finished setting the trace write condition,
click this button. The Realtime-trace Write Condition dialog
box shown below will appear.
Write mode
Only the cycle in which the specified Start event occurred
A range of cycles from when the specified Start event
occurred to when the specified Start event became
nonexistent
A range of cycles from when the specified Start event
occurred to when the specified End event occurred
Page 71 of 98