Nortel Networks 1000BASE-ZX Manual Do Utilizador
100
Chapter 3 Using the console interface
209418-A
System Characteristics screen
The System Characteristics screen (
) allows you to view system
characteristics and contains three user-configurable fields: sysContact, sysName,
and sysLocation.
and sysLocation.
To open the System Characteristics screen:
Read-Write
Community String
Community String
The community string used for in-band read-write SNMP operations.
Default Value
private
Range
Any ASCII string of up to 32 printable characters
Trap #1 IP Address
1
Number one of four trap IP addresses. Successive trap IP address fields
are numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
are numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
Default Value
0.0.0.0 (no IP address assigned)
Range
Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
represented as a decimal value, separated by a decimal
point
Community String
The community string associated with one of the four trap IP addresses
(see Trap #1 IP Address).
(see Trap #1 IP Address).
Default Value
Zero-length string
Range
Any ASCII string of up to 32 printable characters
Authentication Trap
Determines whether a trap will be sent when there is an SNMP
authentication failure.
authentication failure.
Default Value
Enabled
Range
Enabled, Disabled
Autotopology
Allows you to enable or disable the switch participation in autotopology,
which allows network topology mapping of other switches in your network.
which allows network topology mapping of other switches in your network.
Default Value
Enabled
Range
Disabled
1 The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel Networks
proprietary MIB). The status of the row in the MIB table can be set to Ignore. If the row status is set to Ignore,
the fields appear to be set when viewed from the console terminal; however, no traps will be sent to that
address until the row status is set to Valid.
the fields appear to be set when viewed from the console terminal; however, no traps will be sent to that
address until the row status is set to Valid.
Choose System Characteristics (or press s) from the main menu.
Table 11 SNMP Configuration screen fields (continued)
Field
Description