Nortel Networks 1000BASE-ZX Manual Do Utilizador

Chapter 3 Using the console interface

Using the BayStack 420 10/100/1000 Switch

 describes the Renumber Stack Units screen fields.

The Hardware Unit Information screen (

) lists the switch models, 

including any installed GBICs that are configured in your standalone or stack 
configuration.

To open the Hardware Unit Information screen:

Renumber Stack Units screen fields

Read-only fields listing the current unit number of each of the configured stack 
units. The entries in this column are displayed in order of their current physical 
cabling with respect to the base unit, and can show nonconsecutive unit 
numbering if one or more units were previously moved or modified. The entries can 
also include unit numbers of units that are no longer participating in the stack (not 
currently active).

Read-only field listing the MAC address of the corresponding unit listed in the 
Current Unit Number field.

User-settable field showing the current unit number of each unit in the stack. You 
can change any of the fields, as required. You can also delete entries by typing 
zero (0) or using the space bar to clear the field.

Default Value

Current stack order

Range

1 to 8

Specifies whether to start the renumbering process (default is No). Use the 
spacebar to toggle the selection to Yes.

Renumbering resets the switch with the current configuration values. When you 
select this option, the switch resets, runs a self-test, then displays the Nortel 
Networks logo screen. After you press [Ctrl]-Y at the screen prompt, the console 
screen temporarily displays the (standalone) BayStack 420 Switch main menu. 
Then, within 20 seconds, the console screen refreshes and displays the main 
menu screen for the stack configuration. The Unit LEDs display the new 
numbering order.

Default Value

No

Range

No, Yes

Choose Display Hardware Units (or press h) from the main menu.