Nortel Networks 10BASE-T Manual Do Utilizador
Installing the BayStack 410-24T Switch
309985-C Rev 00
2-7
4.
Insert two screws, appropriate for your 19-inch rack, into each of the
mounting brackets and tighten.
mounting brackets and tighten.
5.
After the switch is secured in the rack, proceed to the next section,
“
“
.”
Attaching Devices to the BayStack 410-24T Switch
This section describes how to attach devices to the BayStack 410-24T switch ports
and how to connect a console terminal to the switch Console/Comm port. You can
use the console terminal to observe the power on self-test results and set up the
switch, if required, as described later in this chapter.
and how to connect a console terminal to the switch Console/Comm port. You can
use the console terminal to observe the power on self-test results and set up the
switch, if required, as described later in this chapter.
The BayStack 410-24T switch has an Uplink/Expansion slot that allows you to
attach optional media dependent adapters (MDAs). The MDAs support a range of
media types (see
attach optional media dependent adapters (MDAs). The MDAs support a range of
media types (see
,” for more
information about MDA types available from Nortel Networks). Refer to the
documentation that came with your specific MDA for information about its
cabling and LED indications.
documentation that came with your specific MDA for information about its
cabling and LED indications.
BayStack 410-24T switches provide Fail-Safe stackability when you install the
optional BayStack 400-ST1 Cascade Module to your switches. Installation
instructions are provided with the Cascade Module.
optional BayStack 400-ST1 Cascade Module to your switches. Installation
instructions are provided with the Cascade Module.
Depending on your network configuration requirements, connect the RJ-45 port
cables, the console port, and any optional MDA port cables as described in the
following sections. After attaching the devices to the BayStack 410-24T switch,
proceed to
cables, the console port, and any optional MDA port cables as described in the
following sections. After attaching the devices to the BayStack 410-24T switch,
proceed to
to connect the AC power cord and
power up the switch.
You can connect the BayStack 410-24T switch to any equipment that conforms to
the IEEE 802.3 standard, such as the following devices:
the IEEE 802.3 standard, such as the following devices:
•
Ethernet networking devices
•
Individual workstations or servers
•
Other switches, bridges, or hubs