Nortel Networks 10BASE-T Manual Do Utilizador
Media Dependent Adapters
309985-C Rev 00
B-7
6.
” on
After connecting the port cables, continue to follow the instructions to connect
power and verify the installation.
power and verify the installation.
Replacing an MDA
When replacing an installed MDA:
1.
Power down the switch.
Remove the AC power cord from the power source.
2.
Remove the installed MDA.
Loosen the thumbscrews and remove the MDA.
3.
Install the replacement MDA.
Be sure to firmly tighten the two thumbscrews on the MDA front panel.
4.
Power up the switch.
Note:
The IEEE 802.3u specification requires that all ports operating at 100
Mb/s use only Category 5 unshielded twisted pair (UTP) cabling.