Netgear M4100-26-POE Manual Do Utilizador
Utility Commands
556
ProSafe M4100 and M7100 Managed Switches
write memory
Use this command to save running configuration changes to NVRAM so that the changes
you make will persist across a reboot. This command is the same as copy
system:running config nvram:startup-config
you make will persist across a reboot. This command is the same as copy
system:running config nvram:startup-config
.
Format
write memory
Mode
Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system time
and date by using SNTP.
and date by using SNTP.
sntp broadcast client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 10.
where <poll-interval> can be a value from 6 to 10.
Default
Format
sntp broadcast client poll-interval <poll-interval>
Mode
no sntp broadcast client poll-interval
This command resets the poll interval for SNTP broadcast client back to the default value.
Format
no sntp broadcast client poll-interval
Mode
{image1 | image2}
unit://<unit>/{image1 |
image2}
image2}
Copy an image from the management node to a given
node in a Stack. Use the unit parameter to specify the
node to which the image should be copied.
node in a Stack. Use the unit parameter to specify the
node to which the image should be copied.
{image1 | image2}
unit://*/{image1 |
image2}
image2}
Copy an image from the management node to all of
the nodes in a Stack.
the nodes in a Stack.
Privileged EXEC
6
Global Config
Global Config
Source
Destination
Description