Netgear NETGEAR Manual Do Utilizador

8-120

Switching Commands

This command sets the Configuration Identifier Revision Level for use in identifying the 
configuration that this switch is currently using to the default value, i.e. 0.

This command specifies that this port is an Edge Port within the common and internal spanning 
tree. This will allow this port to transition to Forwarding State without delay. 

This command specifies that this port is not an Edge Port within the common and internal 
spanning tree.

This command sets the Force Protocol Version parameter to a new value. The Force Protocol 
Version can be one of the following:

•

802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality 
supported)

•

802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality 
supported)

•

802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)