Netgear NETGEAR Manual Do Utilizador

Routing Commands

10-9

This command deletes all configured default routes. If the optional <nextHopRtr> parameter is 
designated, the specific next hop is deleted from the configured default route and if the optional 
preference value is designated, the preference of the configured default route is reset to its default.

This command sets the default distance for static routes. Lower route preference values are 
preferred when determining the best route. The "ip route" and "ip route default" commands allow 
you to optionally set the distance of an individual static route. The default distance is used when no 
distance is specified in these commands. Changing the default distance does not update the 
distance of existing static routes, even if they were assigned the original default distance. The new 
default distance will only be applied to static routes created after invoking the "ip route distance" 
command.

1

This command sets the default static route preference value in the router. Lower route preference 
values are preferred when determining the best route.

This command enables forwarding of IP frames. 

enabled