Netgear NETGEAR Manual Do Utilizador

11-14

Quality of Service (QoS) Commands

This command adds to the specified class definition a match condition based on the destination IP 
address of a packet. The <ipaddr>

parameter specifies an IP address. The <

parameter 

specifies an IP address bit mask; note that although similar to a standard subnet mask, this bit mask 
need not be contiguous. The optional [

parameter has the effect of negating this match 

condition for the class (i.e., match all destination IP addresses except for what is specified here).

none

This command adds to the specified class definition a match condition based on the destination 
layer 4 port of a packet using a single keyword or numeric notation or a numeric range notation. 

To specify the match condition as a single keyword, the value for <

is one of the supported 

port name keywords. The currently supported <

values are: 

. Each of these translates into its equivalent port number, which is used as 

both the start and end of a port range.

To specify the match condition using a numeric notation, one layer 4 port number is required. The 
port number is an integer from 0 to 65535. 

To specify the match condition using a numeric range notation, two layer 4 port numbers are 
required and together they specify a contiguous port range. Each port number is an integer from 0 
to 65535, but with the added requirement that the second number be equal to or greater than the 
first.

The optional [not] parameter has the effect of negating this match condition for the class (i.e., 
match all destination layer 4 port numbers except for the one specified here).

none