Netgear NETGEAR Manual Do Utilizador

Quality of Service (QoS) Commands

11-29

Queue depth management defaults to tail drop, but the randomdrop command can be used 

to change to a RED scheme. 

Neither of the shaping rate parameters is allowed to exceed the 
maximum link data rate of the interface to which the policy is 
applied.

Out

Expedite (all forms)

The 'service' command set is used in DiffServ to define:

Assign a DiffServ traffic conditioning policy (as specified by the 
policy commands) to an interface in the incoming direction

Assign a DiffServ service provisioning policy (as specified by the 
policy commands) to an interface in the outgoing direction

The service commands attach a defined policy to a directional interface. Only one policy may be 
assigned at any one time to an interface in a particular direction. The policy type (in, out) must 
match the interface direction to which it is attached.

This set of commands consists of service addition/removal.

The CLI command root is 

This command attaches a policy to an interface in a particular direction. The command can be used 
in the Interface Config mode to attach a policy to a specific interface. Alternatively, the command 
can be used in the Global Config mode to attach this policy to all system interfaces. The direction 
value is either in or out. The <

 parameter is the name of an existing DiffServ policy, 

whose type must match the interface direction. Note that this command causes a service to create a 
reference to the policy.

This command effectively enables DiffServ on an interface (in a particular direction). There 

is no separate interface administrative 'mode' command for DiffServ.