Netgear NETGEAR Manual Do Utilizador

11-40

Quality of Service (QoS) Commands

The name of the policy attached to the interface.

None of the counters listed here are guaranteed to be supported 
on all platforms. Only supported counters are shown in the dis-
play output.

This chapter provides a detailed explanation of the software QoS CoS commands. The following 
commands are available in the software QOS module.

The commands are divided into these different groups:

•

Configuration Commands are used to configure features and options of the switch. For every 
configuration command there is a show command that will display the configuration setting.

•

Show commands are used to display device settings, statistics and other information. 

The 'Interface Config' mode only affects a single interface, whereas the 'Global Config' 

mode is applied to all interfaces. 

This command maps an 802.1p priority to an internal traffic class.  The userpriority and 
trafficclass can both range from 0-7, although the actual number of available traffic classes 
depends on the platform.  The 'no' form of this command is not supported.

This command maps an IP DSCP value to an internal traffic class.  The ipdscp range is from 0-63 
and the trafficclass range is from 0-7, although the actual number of available traffic classes 
depends on the platform.  The 'no' form of this command is not supported.