Netgear NETGEAR Manual Do Utilizador

8-14

Switching Commands

The value of the corresponding instance was added by the system 
or a user when a static MAC filter was defined. It cannot be 
relearned.

The value of the corresponding instance was learned by observ-
ing the source MAC addresses of incoming traffic, and is cur-
rently in use.

The value of the corresponding instance (system MAC address) is 
also the value of an existing instance of dot1dStaticAddress. It is 
identified with interface 0/1 and is cur

rently used when enabling 

VLANs for routing.

The value of the corresponding instance is the address of one of 
the switch’s physical interfaces (the system’s own MAC address).

The value of the corresponding was learned via GMRP and 
applies to Multicast.

The value of the corresponding instance does not fall into one of 
the other categories.

This command displays the message log maintained by the switch. The message log contains 
system trace information.

The trap log contains a maximum of 256 entries that wrap. 

 

The message that has been logged. 

Message log information is not retained across a switch reset.

This command is used to display the current setting of different protocol packages supported on 
switch. This command displays only those parameters, the values of which differ from default 
value. The output is displayed in the script format, which can be used to configure another switch 
with same configuration.