Netgear XS712T-100NES Manual Do Utilizador
138
XS712T Smart Switch
IP Configuration
Use the IP Configuration screen to configure routing parameters for the switch.
To enable routing on the switch:
1.
Select Routing
IP
> IP Configuration.
2.
Next to Routing Mode, select Enable.
You must enable routing for the switch before you can route through any of the interfaces.
Routing is also enabled or disabled per VLAN interface. The default value is Disable.
Routing is also enabled or disabled per VLAN interface. The default value is Disable.
The following table describes the IP configuration information displayed on the screen.
Field
Description
Default Time to Live
The default value inserted into the Time-To-Live field of the IP
header of datagrams originated by the switch, if a TTL value is not
supplied by the transport layer protocol. The default value is 64.
header of datagrams originated by the switch, if a TTL value is not
supplied by the transport layer protocol. The default value is 64.
Maximum Next Hops
The maximum number of hops supported by the switch. This is a
compile-time constant. The default value is 1.
compile-time constant. The default value is 1.
3.
Click Apply.
IP Statistics
The statistics reported on the IP Statistics screen are as specified in RFC 1213.
To display the IP statistics screen:
Select Routing
IP
>Statistics. The IP Statistics screen displays.