Netgear WFS709TP Manual Do Utilizador

14-2

Configuring WFS709TP for Voice

Battery boost converts all multicast traffic to unicast before delivery to the client. This feature is 
disabled by default. Enabling battery boost on an SSID allows you to set the DTIM interval from 
10 to 100, equating to 1,000–10,000 milliseconds. This longer interval keeps associated wireless 
clients from activating their radios for multicast indication and delivery, leaving them in power-
save mode longer, and thus lengthening battery life. The DTIM configuration is performed on the 
WLAN, so no configuration is necessary on the client. Although the multicast-to-unicast 
conversion generates more traffic, that traffic is buffered by the AP and delivered to the client 
when the client emerges from power-save mode.

An associated parameter available on some clients is the Listening Interval (LI), which defines the 
interval (in number of beacons) after which the client must wake to read the Traffic Indication Map 
(TIM). The TIM indicates whether there is buffered unicast traffic for each sleeping client. With 
battery boost enabled, the DTIM is increased but multicast traffic is buffered and delivered as 
unicast. Increasing the LI can further increase battery life, but can also decrease client 
responsiveness. NETGEAR recommends a DTIM setting of 10 or less for NEC FOMA N900iL 
clients, and 30 or less for BlackBerry 7270 clients.

You enable the battery boost feature and set the DTIM interval in the WLAN configuration.

To enable battery boost:

1. Navigate to the Configuration > Advanced > WLAN > Advanced page.

2. Click Add to add a new location.

3. Enter a location ID in the format building.floor.plan, where each value is an integer.

4. Click Add.

5. Select the 802.11b/g or 802.11a tab to configure radio settings.

6. Select Battery Boost.

7. Configure the DTIM Period if needed.

8. Click Apply.