Netgear WFS709TP Manual Do Utilizador
![Netgear](https://files.manualsbrain.com/attachments/cf1ad5de25a3f8d6c88ef0ab489c1b137eebe11f/common/fit/150/50/17742d1e0cdacf24edeb88c30757620088415c5f7699f69b4517262e21e0/brand_logo.jpeg)
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
2-10
Deploying a Basic WFS709TP System
v1.1, November 2008
Configure a VLAN for Network Connection
Follow the instructions in this section only if you need to configure a trunk port between the
WFS709TP and another Layer 2 switch (as in
WFS709TP and another Layer 2 switch (as in
).
This section shows how to use the browser interface for the following configurations:
•
Create a VLAN on the WFS709TP and assign it an IP address.
•
Assign to the VLAN the port or ports that you will use to connect the WFS709TP to the
network. (For example, the uplink ports that you connect to a router are usually Gigabit ports.)
network. (For example, the uplink ports that you connect to a router are usually Gigabit ports.)
•
Configure the ports as trunk ports.
•
Configure a default gateway for the WFS709TP.
Create the VLAN
The following configurations create VLAN 5 and assign it the IP address 10.3.22.20/24.
1. Navigate to the Configuration > Basic > Network >VLAN page.
2. Click Add to create a new VLAN.
3. On the Add New VLAN screen (
), enter 5 for the VLAN ID and click Apply.
Note: In the browser interface configuration pages, clicking the Apply button saves
configuration changes so they are retained after the WFS709TP is rebooted.
Figure 2-7