3com 5500-SI Manual Do Utilizador

C

HAPTER

 22: F

ILE

 S

YSTEM

 M

ANAGEMENT

To send information to the log buffer, follow the steps below:

1 Enabling info-center

Perform the following operation in System View.

Table 543   Enabling/Disabling Info-center

2 Configuring to output information to the log buffer

Perform the following operation in System View.

Table 544   Configuring to Output Information to Log Buffer

3 Configuring the information source on the Switch

With this configuration, you can define the information that is sent to the log buffer: 
generated by which modules, information type, information level, and so on.

Perform the following operation in System View:

Table 545   Defining the Information Source

specifies the module name; 

 represents all the modules; 

 

refers to the severity levels; 

 specifies the severity level of information. The 

information with the level below it will not be output. 

specifies the 

channel number and 

 specifies the channel name.

When defining the information sent to the log buffer, 

 or 

 must be set to the channel that corresponds to the Console direction.

Every channel has been set with a default record, whose module name is 

 

and the module number is 0xffff0000. However, for different channels, the default 
record may have different default settings of log, trap and debugging. When there is 
no specific configuration record for a module in the channel, use the default one.

Disable terminal display function of trap information

Enable info-center

Disable info-center

Output information to log buffer

info-center logbuffer [ channel { 
channel-number

 | channel-name } ] [ size 

 ]

Cancel the configuration of 
outputting information to log buffer

Define information 
source

 modu-name | default } channel { 

 | channel-name } [ { log | trap | debug 

severity | state

 state }* ]

Cancel the 
configuration of 
information source

 modu-name | default } channel 

 | channel-name }