3com 4007 Manual Do Utilizador
38
C
HAPTER
3: I
NSTALLING
THE
S
WITCH
4007
Installing the Chassis on a Table or Shelf
This section describes how to attach plastic feet to the
chassis and how to install the chassis on a table or a
shelf.
chassis and how to install the chassis on a table or a
shelf.
WARNING: Safety regulations state that the selected
table or shelf must be able to support at least 115.6
kg (255 lb), which is three times the weight of a fully
loaded chassis.
table or shelf must be able to support at least 115.6
kg (255 lb), which is three times the weight of a fully
loaded chassis.
Attaching the Chassis Feet
To install plastic, molded feet on the Switch 4007
chassis, follow these steps:
chassis, follow these steps:
1
Using two people, lift the chassis onto the table or
shelf.
shelf.
2
Position the chassis on its side so that you can access
the bottom of the chassis.
the bottom of the chassis.
3
Remove the four feet and the four 6-32 Phillips-head
screws from the hardware kit.
screws from the hardware kit.
4
Using a Phillips screwdriver, screw the feet to the
bottom of the chassis. See Figure 9.
bottom of the chassis. See Figure 9.
Figure 20 Attaching Plastic Feet to the Switch 4007 Chassis
Installing the Chassis on a Table or Shelf
To install the chassis on a table or on a shelf, follow
these steps:
these steps:
1
Lift and turn the chassis upright on its installed plastic
feet.
feet.
2
Position the chassis on the table or shelf so that the
chassis rests upright squarely on the table or on the
shelf (on all four feet).
chassis rests upright squarely on the table or on the
shelf (on all four feet).
3
Ensure that the front, sides, and the rear of the chas-
sis are unobstructed and easy to reach.
sis are unobstructed and easy to reach.