3com WX1200 Manual Do Utilizador
set dap fingerprint
331
Usage — Changing the LED blink mode does not alter operation of the
MAP access point. Only the behavior of the LEDs is affected.
MAP access point. Only the behavior of the LEDs is affected.
Examples — The following command enables LED blink mode on the
MAP access points connected to ports 3 and 4:
MAP access points connected to ports 3 and 4:
WX1200# set ap 3-4 blink enable
success: change accepted.
success: change accepted.
set dap fingerprint
Verifies a MAP’s fingerprint on a WX switch. If MAP-WX security is
required by a WX switch, a MAP can establish a management session
with the switch only if you have verified the MAP’s identity by verifying its
fingerprint on the switch.
required by a WX switch, a MAP can establish a management session
with the switch only if you have verified the MAP’s identity by verifying its
fingerprint on the switch.
Syntax —
set dap num fingerprint hex
num
— Number of the Distributed MAP whose fingerprint you are
verifying.
hex
— The 16-digit hexadecimal number of the fingerprint. Use a
colon between each digit. Make sure the fingerprint you enter
matches the fingerprint used by the MAP.
matches the fingerprint used by the MAP.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — MAPs are configured with an encryption key pair at the
factory. The fingerprint for the public key is displayed on a label on the
back of the MAP, in the following format:
factory. The fingerprint for the public key is displayed on a label on the
back of the MAP, in the following format:
RSA
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
aaaa:aaaa:aaaa:aaaa:
aaaa:aaaa:aaaa:aaaa
If a MAP is already installed and operating, you can use the display dap
status command to display the fingerprint. The display dap config
command lists a MAP’s fingerprint only if the fingerprint has been verified
in MSS. If the fingerprint has not been verified, the fingerprint
information in the command output is blank.
status command to display the fingerprint. The display dap config
command lists a MAP’s fingerprint only if the fingerprint has been verified
in MSS. If the fingerprint has not been verified, the fingerprint
information in the command output is blank.