3com 3CR17662-91 Manual Do Utilizador
Manually Configuring IP Information
37
You should use the automatic IP configuration method if:
■
your network uses DHCP to allocate IP information, or
■
flexibility is needed. If the Switch is deployed onto a different subnet,
it will automatically reconfigure itself with an appropriate IP address,
instead of you having to manually reconfigure the Switch.
it will automatically reconfigure itself with an appropriate IP address,
instead of you having to manually reconfigure the Switch.
If the Switch is not allocated with an automatic IP address, the IP
configuration will be blank or shown as ‘’’’.
configuration will be blank or shown as ‘’’’.
If you use the automatic IP configuration method, you need to discover
the automatically allocated IP information before you can begin
management. Work through the “Viewing Automatically Configured IP
Information” on page 44.
the automatically allocated IP information before you can begin
management. Work through the “Viewing Automatically Configured IP
Information” on page 44.
Preparing for
Management
Once your Switch’s initial set up is complete you can set up your chosen
management method as described in “Methods of Managing a Switch”
on page 32.
management method as described in “Methods of Managing a Switch”
on page 32.
For detailed information about the specific web interface operations and
command line interface commands and problem solving, refer to the
“Switch 4200G Command Reference Guide” on the CD-ROM that is
supplied with the Switch or on the 3Com Web site.
command line interface commands and problem solving, refer to the
“Switch 4200G Command Reference Guide” on the CD-ROM that is
supplied with the Switch or on the 3Com Web site.
Manually
Configuring IP
Information
Configuring IP
Information
You can manually configure the Switch IP information in the following
ways:
ways:
■
Connecting to the console port
Connect a workstation using a console cable to the console port of
the Switch. You can then manually enter IP information using the
command line interface (CLI).
the Switch. You can then manually enter IP information using the
command line interface (CLI).
■
Connecting to a front panel port
Connect a workstation using an Ethernet cable to a front panel port
of the Switch. You can then manually enter IP information using the
web interface or the command line interface (CLI).
of the Switch. You can then manually enter IP information using the
web interface or the command line interface (CLI).
10014914AA.book Page 37 Friday, July 7, 2006 2:08 PM