3com 3800 Manual Do Utilizador

Table 4-11 describes PACE commands.

config port <portlist> auto off {speed 
[10 | 100]} duplex [half | full]

Allows you to change the configuration of a group of 
10/100 Mbps ports. Specify the following:

■

auto off — The port will not autonegotiate the 
settings.

■

speed — The speed of the port (for 10/100 Mbps 
ports only).

■

duplex — The duplex setting (half- or full-duplex).

config port <portlist> auto off duplex 
full

Allows you to disable autonegotiation on a Gigabit 
port.

enable port <portlist>

Allows you to enable one or more ports.

enable sharing <master_port> grouping 
<portlist>

Allows you to define a load-sharing group of ports. 
The ports specified in <portlist> are grouped to the 
master port.

enable smartredundancy <portlist>

Allows you to enable the SmartRedundancy feature on 
the redundant Gigabit Ethernet port. When the 
SmartRedundancy feature is enabled, the Switch 
always uses the primary link when the primary link is 
available. The default setting is enabled.

disable port <portlist>

Allows you to disable one or more ports.

disable sharing <master_port>

Allows you to disable a load-sharing group of ports.

disable smartredundancy <portlist>

Allows you to disable the SmartRedundancy feature. If 
the feature is disabled, the Switch changes the main 
link only when the current main link becomes 
inoperable.

Table 4-10   Port Commands

Table 4-11   PACE Commands

enable pace

Allows you to enable recognition of the PACE bit.

disable pace

Allows you to disable recognition of the PACE bit.

SW3800.BK  Page 13  Tuesday, May 5, 1998  5:20 PM