3com 3800 Manual Do Utilizador

config syslog <ipaddress> <facility> 
{<priority>} {<subsystem>}

Allows you to configure the syslog host address and 
filter messages sent to the syslog host. Options include:

■

ipaddress — The IP address of the syslog host.

■

facility — The syslog facility level for local use.

■

priority — Filters the log to display message with the 
selected priority or higher (more critical). Priorities 
include critical, warning, and informational. If not 
specified, only critical priority messages are sent to 
the syslog host.

■

subsystem — Filters the log to display messages 
associated with the selected Switch subsystem. 
Subsystems include Syst, STP Brdg, SNMP, Telnet, 
VLAN, and Port. If not specified, all subsystems are 
sent to the syslog host.

enable log display

Allows you to enable the log display.

enable syslog

Allows you to enable logging to a remote syslog host.

disable log display

Allows you to disable the log display.

disable syslog

Allows you to disable logging to a remote syslog host.

Table 4-18   Logging Commands (continued)

Table 4-19   Configuration and Image Commands 

save {config} {primary | secondary}

Allows you to save the current configuration of the 
Switch to NVRAM. You can specify the primary or 
secondary configuration area. If not specified, the 
configuration is saved to the configuration area 
currently in use.

use config {primary | secondary}

Allows you to configure the Switch to use a particular 
configuration on the next reboot. Options include the 
primary configuration area, the secondary 
configuration area, or an imported ASCII file. If not 
specified, the Switch will use the primary configuration 
area.

use image {primary | secondary}

Allows you to configure the Switch to use a particular 
image on the next reboot. If not specified, the Switch 
will use the primary image.

(continued)

SW3800.BK  Page 23  Tuesday, May 5, 1998  5:20 PM